Product Overview
NPG 247 / 249J Main Shaft SnapRing (Aproximate Dimensions: 34.45mm x 27.75mm x 2.35mm) (Good-Used)
NPG 247 / 249J Main Shaft SnapRing (Aproximate Dimensions: 34.45mm x 27.75mm x 2.35mm) (Good-Used)
NP-241 / 242 / 249 / 247 Jeep Input Shaft SnapRing (Sits On The Input Shaft and Holds Bearing Number 6010N) (Aprox Dimension 56.85mm x 47.30mm x 2.40mm)
NP 247J, 249Jeep Intermediate Shaft Spring (Between the Intermediate Shaft and Intermediate Shaft Collar) Aprox Dim.: 62.69mm x 57.25mm x 43.00mm (Good-Used)
Jeep NP249 Intermediate Shaft Snap Ring (Aprox Dimensions 48mm x 41.70mm x 1.57mm) (Good-Used)
NP 247J Main Shaft (Jeep) 27 / 34 Splines (16 1/4 Inches Tall) (Good-Used)
NP 242, 247, 249 (Jeep) Front Output Yoke (3 7/8" Tall) 4 Bolt Holes - Center to Center 2 3/8" & 1 5/8" (32 Spline) 19056 (Good-Used)
NP 249-J Transfer Case Part Snap Ring (Sits on Main Shaft Right Behind the Pump) (Aprox. Dim.: 47.45mm x 39.50mm x 1.58mm) (Good-Used)
BW 4470 Snap Ring (Goes on Main Shaft Behind the Tone Wheel (Sensor Wheel) (Presses against Rear Output Bearing Number 6208) (Good-Used)
NP-241C, 242J, NP247J Front Output Bearing SnapRing (Aprox Dim 76.25mm OD x 66.80mm ID x 2.20mm H) Sits Inside the Case to Hold Bearing 6207) (Previous Part Number U361860J-FOB)